Sonnet-technologies Tempo SSD PCI Express 2.5 SSD Host Card Manual de usuario descargar pdf (Pagina 5)

SSD Installation Steps

Single SSD Installation

If you intend to install two SSDs, skip to the next

page. Otherwise, perform the steps below.

1. If you haven’t already done so, remove the

Sonnet card from its packaging, handling the

card by its edges and without touching any

components or gold connector pins. Set the

card down on a ﬂat, level surface.

2. Remove the SSD from its packaging.

3. Place the SSD label side up on top of

the Tempo SSD card with the SSD’s and

card’s connectors aligned with each other

(Figure 2).

4. Push the SSD’s connector into the Tempo

SSD’s connector until the SSD is completely

seated (Figure 2).

5. Holding the SSD ﬁrmly against the card, ﬂip

the assembly over.

6. Using the included package of four screws,

secure the SSD to the Tempo SSD card; do not

overtighten the screws (Figure 3).

Figure 2

Figure 3

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Sonnet-technologies Tempo SSD PCI Express 2.5 SSD Host Card Manual de usuario Pagina 5