Sonnet-technologies Fusion QR (Without Drives) Manual de usuario

4-Drive Hardware RAID 5 SATA Disk Enclosure with Quad Interface FUSION™ QRUser’s GuideForWindows

63 – Drive Mode DescriptionsRAID 5: Striping, Parity Distributed Among DrivesRAID 5 configuration increases reliability while using fewer drives than R

7Initial Drive Mode ConfigurationWhen you first turn on the Fusion QR after installing the hard drives, you must select a mode to configure the drives b

OS X Users’ Instructions 1. After the Fusion QR finishes configuring the drives, a Disk Insertion window will appear stating that there is an unreadabl

96 – Status LED IndicationsSystem Powered, No Drive ActivityWhen the Fusion QR is powered on, and no data is being written to or read from the drives,

Specifications External Connectors USB 3.0, eSATA, two FireWire 800Drives Supported Up-to-date compatible hard drives listed on our Certified Hard Driv

1 Fusion QR Features 12 Drive Installation and Enclosure Setup 2 Install Drives Connect the Fusion QR to Computer and Power Outlet3 Drive

1 – Fusion QR Features11 – Power Indicator This blue LED lights when the Fusion QR is powered.2 – Presence, Activity, and Fault Indicators — Drives

Install Drives 1. Remove the Fusion QR from its packaging, and place it on a flat, level surface, with the front panel facing you. 2. Lift up the fro

5. Remove a drive from its packaging and set it in on a flat, level surface with the label side up. Open the supplied tube of threadlocker, and then

Connect the Fusion QR to Computer and Power Outlet 1. Using one of the supplied cables (eSATA, FireWire 800, USB 3.0), connect the Fusion QR to your

53 – Drive Mode DescriptionsThe following two pages describe the drive modes supported by the QR. To configure the Fusion DE400-QR’s drives, refer to D